Toshiba e-studio 160 - Removal and Reinstallation of Covers and PC Boards; Cover Removal - Control Panel, Ozone Filter, Paper Tray

December 2002 TOSHIBA TEC 2 - 23 e-STUDIO160/200/250 OUTLINE OF THE MACHINE
Control panel
Screw
Control panel harness
Ground wire
Screw
007
Screw
Clamp
Core
dropping.
Fig. 2-6-8
[J] Paper tray cover
1. If a Finisher (MJ-1011) is attached to the copier,
detach the finisher plate and junction block.
2. If a JSP (MJ-5001) or OCT (MJ-5002) is
attached to the copier, detach it.
3. Detach the toner cartridge.
4. Detach ozone cover. (See Fig. 2-6-9)
5. Remove 3 screws, release 2 tabs, and detach
power switch cover.
6. Detach paper tray cover.
[I] Ozone filter 1/ozone cover
1. If a JSP (MJ-5001) or OCT (MJ-5002) is attached
to the copier, detach the tray.
2. Lift ozone cover off while holding both sides.
3. Detach ozone filter 1.
Fig. 2-6-9
Fig. 2-6-10
Ozone cover
Ozone filter 1
Ozone cover
Paper tray cover
Screw
Power switch
cover
008
009
[H] Control panel
1. If a Finisher (MJ-1011) is attached to the copier,
detach the finisher plate.
2. If an Original Cover (KA-1600PC), ADF (MR-2012),
or the RADF (MR-3011) is attached to the copier,
open it.
3. Detach scanner cover. (See Fig. 2-6-3)
4. Detach control panel front cover.
(See Fig. 2-6-6)
5. Detach control panel bottom cover.
(See Fig. 2-6-7)
6. Remove one screw and detach the ground wire.
7. Detach control panel harness.
8. Remove 2 screws at the lower part of control
panel, release 2 hooks, and remove control
panel.
Note: When attaching the control panel, secure it
with the clamp to prevent the core from
dropping.