Toshiba e-studio 160 - Disassembly and Replacement (Paper Feeding); Pickup Assembly, Feed Roller, and Pickup Roller

December 2002 TOSHIBA TEC 9 - 11 e-STUDIO160/200/250 PAPER FEEDING SYSTEM
[E] Pickup feed roller
1. If an ADU (MD-0101) and/or SFB (MY-1016)
are attached to the copier, detach it.
2. Remove paper cassette. (See Fig. 2-6-11)
3. Remove upper right cover R and lower right
cover R. (See Fig.2-6-14)
4. Remove separation holder assembly.
(See Fig. 9-7-1)
5. Remove pickup assembly. (See Fig. 9-7-4)
6. Remove stop ring and remove pickup feed
roller.
Clutch
Stop ring
Pickup feed roller
073
Fig. 9-7-4
Screw
Pickup assembly
072
Fig. 9-7-5
[F] Pickup roller
1. If an ADU (MD-0101) and/or SFB (MY-1016)
are attached to the copier, detach it.
2. Remove paper cassette. (See Fig. 2-6-11)
3. Remove upper right cover R and lower right
cover R. (See Fig.2-6-14)
4. Remove separation holder assembly.
(See Fig. 9-7-1)
5. Remove pickup assembly. (See Fig. 9-7-4)
6. Release 2 hooks.
Fig. 9-7-6
Pickup roller shaft
assembly
Timing belt 124
080
Pulley
Pickup roller shaft
Clutch
E-ring
081
7. Release timing belt 124 and remove pickup
roller shaft assembly.
8. Detach E-ring and remove pulley and clutch.
9. Detach 2 E-rings.
E-ring
[D] Pickup assembly
1. If an ADU (MD-0101) and/or SFB (MY-1016)
are attached to the copier, detach it.
2. Remove paper cassette. (See Fig. 2-6-11)
3. Remove upper right cover R and lower right
cover R. (See Fig.2-6-14)
4. Remove separation holder assembly.
(See Fig. 9-7-1)
5. Remove 2 screws and remove pickup assem-
bly.
Fig. 9-7-7