Toshiba e-studio 160 - Removal and Reinstallation of Covers and PC Boards; PC Board Removal - RELAY PWA; PC Board Removal - PC I;F PWA

e-STUDIO160/200/250 OUTLINE OF THE MACHINE 2 - 32 December 2002 TOSHIBA TEC
[B] RELAY PWA
1. If a STP (KK-1600) is attached to the copier,
disconnect the power cable.
2. Detach the manual pocket.
3. Detach rear cover. (See Fig. 2-6-1)
4. If a FAX kit (GD-1061) is attached to the copier,
detach the FAX PWA and NCU PWA.
5. If a PCL kit (GA-1031) or Memory (GC-1050)
is attached to the copier, detach it.
6. If a NIC kit (GF-1110) or I-FAX (GD-1070) is
attached to the copier, unplug the connectors
for CN14 and CN17.
7. If finisher (MJ-1011) is attached to the copier,
detach the finisher PWA.
8. Remove MAIN PWA.
(See Fig. 2-6-25 and 2-6-26)
9. Detach all the connectors from RELAY PWA.
10. Remove 4 screws and remove RELAY PWA.
Fig. 2-6-27
RELAY PWA
Screw
RELAY PWA
024
[C] PC I/F PWA
1. If a STP (KK-1600) is attached to the copier,
disconnect the power cable.
2. Detach the manual pocket.
3. Detach rear cover. (See Fig. 2-6-1)
4. Remove one screw, detach PC I/F PWA cover,
and detach the connector.
5. Remove 2 screws and remove PC I/F PWA.
Fig. 2-6-28
PC I/F PWA
PC I/F PWA
CN2
Screw
PC I/F PWA cover
Screw
025