30 Network Administrator’s Guide — Setup Flow for Printing Features
Setup procedure
Step 1: Setting up the TCP/IP and the HTTP Network Service to enable TopAc-
cess.
You should set the TCP/IP and HTTP Network Service from the Touch Panel Display the
first time you use it, to make TopAccess available. Please see the User Functions Guide to
configure the TCP/IP and HTTP Network Service from the Touch Panel Display, or from
TopAccess.
 P.53 "Setting up the TCP/IP"
 P.58 "Setting up the HTTP Network Service"
Step 2: Setting up the LPD Print Service.

P.91 "Setting up the LPD Print"
Step 3: Advise users to install the Macintosh PPD file.
Users can install the Macintosh PPD file from the Client1 CD-ROM. For more information
about the Macintosh PPD file installation and setting up LPR printing on the Macintosh
computer, please see the Printing Guide.
Setup Flow for Unix Printing
This equipment supports printing for Unix workstations using the Unix Filters.
System Requirements
Unix printing applies the following Unix workstations:
OS: Sun Solaris 2.6/2.7/7.8/8/9
HP-UX ver.10.20/11.x
IBM AIX 4.1.5/4.3.3/5L
SCO UnixWare 7
SCO OpenUnix 8
Red Hat Linux 6.2/7.1/7.2/7.3/8.0
SuSE Linux ver.7.0/8.1
Mandrake Linux ver.7.1/9
Turbo Linux 8
This equipment can be used with the LPR printer connection when the Unix workstations and
the equipment are connected over the TCP/IP network.
Unix workstation
Connecting over TCP/IP Network
Setting up the LPR
printer connection
To Next Page
Loading...
Need help?
General
