Network Administrator’s Guide — Setting up Print Service Settings 91
4. Click [Save].
• The confirmation dialog box appears.
SUPPLEMENT: • If you want to restore the current settings without saving the changes, click [Cancel].
Clicking [Cancel] cannot restore the defaults. This can only clear the changes and
restore the current settings before saving the changes.
5. Click [OK] to apply the changes.
NOTE: • When using the Internet Explorer, the settings that are displayed in each field may
not be changed even if you change the settings and click [Save]. However, the set-
tings have been changed in the equipment. In that case, click the Print Service sub-
menu then the page displays the current settings in each field.
Setting up the Raw TCP Print
In Raw TCP Print, you can enable or disable the Raw TCP print service.
1) Enable Raw TCP
Enable or disable Raw TCP print service.
2) Port Number
If enabling the Raw TCP, enter the Raw TCP port number for the Raw TCP print. Generally
“9100” is used.
3) Enable Raw bi-directional
Enable or disable Raw bi-directional communication.
Setting up the LPD Print
In LPD Print, you can set the LPD print options to enable the LPD/LPR print service.
1) Enable LPD
Enable or disable LPD print service.
2) Port Number
If enabling the LPD, enter the LPD port number. Generally “515” is used.
1
2
3
1
2
3
To Next Page
Loading...
Need help?
General
