4 Installing Client Software for UNIX
196 Setting Up the CUPS
DIN
Finishing
Option Value Alternative Value Description
Private Print Document
ID - Digit 1 to Digit 5
0 to 9 Specify the 5-digit document pass-
word when “Private - Password” is
selected for “Print Modes”.
[Continue] button Determines the selected items.
Option Value Alternative Value Description
Destination Inner Tray
Job Separator Upper
Job Separator Lower
Tray 1
Tray 2
Select the destination.
Hole Punch Off
Long Edge Punch without rotation
Short Edge Punch without rotation
Long Edge Punch with 180 degree
rotation
Short Edge Punch with 180 degree
rotation
Select whether or not a print job is
hole punched.
Stapling Off
Upper Left (Portrait)/Upper Right
(Landscape)
Middle Left (Portrait)/Middle Top
(Landscape)
Lower Left (Portrait)/Upper Left
(Landscape)/Upper Right (Portrait)/
Lower Right (Landscape)
Middle Right (Portrait)/Middle Bottom
(Landscape)
Lower Right (Portrait)/Lower Left
(Landscape)
Middle Top (Portrait)/Middle Right
(Landscape)
Middle Bottom (Portrait)/Middle Left
(Landscape)
whether a print job is stapled.
“Saddle Stitch (Portrait)/Saddle Stitch
(Landscape)” can be selected only
when the Saddle Stitch Finisher is
installed.
[Continue] button Determines the selected items.
To Next Page
Loading...
