Installing Client Software for SMB Printing 71
10
The installation is completed.
Before using the printer driver for printing, please configure the installed options of the
equipment and department code (if required) on the printer driver.
P.206 “Before Using the Printer Driver”
Installation for SMB Printing by Point and Print
The procedure to install the printer driver for SMB printing by Point and Print differs depending
on the version of Windows used.
P.71 “Windows NT 4.0/2000/XP/Server 2003/Vista”
P.73 “Windows 98/Me”
It assumes using SMB printing by Point and Print in a small network. If you can use the Win-
dows NT 4.0, Windows 2000, Windows XP, Windows Server 2003, or Windows Vista as a print
server, it is recommended to set up for printing via Windows print server. For further information
about setting up printing via a Windows print server, see the Network Administration Guide.
y TopAccessDocMon is also available for SMB printing. To install TopAccessDocMon, you
must install it from the Client Utilities CD-ROM separately.
y The Font Manager is also available to install and manage the TrueType fonts on your com-
puter. To install the Font Manager, you must install it from the Font CD-ROM that comes with
the Printer Kit or Printer/Scanner Kit.
P.386 “Installing Font Manager”
Windows NT 4.0/2000/XP/Server 2003/Vista
Installing the printer drivers for SMB printing by Point and Print
The following describes an installation on Windows XP. The procedure is the same when other
versions of Windows are used.
You must log into Windows as a user who has the “Administrators” or “Power Users” privilege.
You must log into Windows as a user who has the “Administrators” privilege when using Win-
dows XP/Server 2003/Vista.
To Next Page
Loading...
Need help?
General
