1.TROUBLESHOOTING FOR THE HARDWARE
Clearing a Paper Misfeed 39
1 TROUBLESHOOTING FOR THE HARDWARE
Misfeed when making copies or prints (using a drawer)
1
Clear the paper misfeed following the guidance shown on the touch panel.
3
Close all the drawers or covers.
4
Press [YES] when “Cancel print job?” appears.
The print job is canceled.
If you do not want to cancel the print job
To restart the job without canceling it, replace the paper in the drawer with that corresponding to the size set in the
equipment after the paper misfeed is cleared. Then if you press [NO] in step 4, the job can be restarted. In this
case, it is not necessary to follow step 5 and later.
2
Open the paper source drawer, check that the guide
width is correct and there is no folded/curled paper or
overloading, and then close the drawer.
Be sure that the height of the stacked paper does not exceed the
line indicated inside of the side guides.
5
Press the [USER FUNCTIONS] button on the control
panel.
To Next Page
Loading...
