1 TROUBLESHOOTING FOR THE HARDWARE
Cleaning the Slit Glass and Main Chargers 63
Cleaning the Slit Glass and Main Chargers
Follow the procedure below to clean the slit glass and the main chargers.
Cleaning the slit glass
1
Open the front cover of the equipment.
2
The slit glass cleaner is placed inside the front cover.
Press and release the latch of the holder to take out
the slit glass cleaner.
3
Remove the white cap.
y Do not touch the slit glass cleaner pad, because the toner on
the pad may stick to your hands and the cleaner pad may be
stained.
y Use the slit glass cleaner with its pad side facing down.
4
Insert the cleaner through the service hole of each
developer unit to clean the slit glass.
To Next Page
Loading...
