Toshiba e-studio 2040c - Staple Jam in the Saddle Stitch Unit (MJ-1106)

1.TROUBLESHOOTING FOR THE HARDWARE
Clearing a Staple Jam 47
1 TROUBLESHOOTING FOR THE HARDWARE
 Staple jam in the Saddle Stitch unit (MJ-1106)
1
Open the front cover of the finisher, and pull out the
Saddle Stitch unit until it stops.
2
Remove the staple cartridge.
3
Raise the guide while holding the knob.
Do not touch the stapling area.
The actual needle point could cause you personal injury.
4
Remove the jammed staples.
5
Holding the knob, lower the guide, and return it to its
original position.
2
1
2
1