1.TROUBLESHOOTING FOR THE HARDWARE
Clearing a Paper Misfeed 27
1 TROUBLESHOOTING FOR THE HARDWARE
7
Close the automatic duplexing unit.
Paper misfeed in the Job Separator and the Offset Tray (both optional)
The procedure below is for e-STUDIO256 with the Job Separator or the Offset Tray installed. The same procedure also
applies to e-STUDIO306LP with the Job Separator installed. However, it does not apply to e-STUDIO356/456/506 with the
Job Separator installed.
Be careful not to let your fingers be caught between the equipment and the duplexing unit or automatic
duplexing unit.
This could injure you.
Do not touch the fuser unit or the metal portion around it.
Since they are very hot, you could be burned or the shock could cause you to get your hand injured in the machine.
6
Close the transport guide holding the green knob.
1
Open the automatic duplexing unit on the right.
2
Open the cover inside of the equipment.
To Next Page
Loading...
