Toshiba e-STUDIO 206L - Register Scan Settings as Templates

1 TROUBLESHOOTING FOR THE HARDWARE
58 Clearing a Staple Jam
 Staple jam in the Saddle Stitch unit
 Saddle Stitch finisher MJ-1106
1
Open the front cover of the finisher, and pull out the
Saddle Stitch unit until it stops.
2
Remove the staple cartridge.
3
Raise the guide while holding the knob.
Do not touch the stapling area.
The actual needle point could cause you personal injury.
4
Remove the top staple sheet.
5
Holding the knob, lower the guide, and return it to its
original position.
2
1
2
1