Toshiba e-STUDIO 206L - Clearing a Staple Jam; Staple Jam in the Finisher

1 TROUBLESHOOTING FOR THE HARDWARE
52 Clearing a Staple Jam
Clearing a Staple Jam
When a staple jam has occurred in the stapler of the finisher or saddle stitch unit, clear the jam following the procedure
below.
 P.52 “Staple jam in the finisher”
 P.58 “Staple jam in the Saddle Stitch unit”
 Staple jam in the finisher
 Finisher MJ-1101 / MJ-1106
1
Open the front cover of the finisher.
An illustration of MJ-1101 is given in the right-hand figure.
2
Remove the staple cartridge.
3
Lower the guide while holding the knob.
Do not touch the stapling area.
The actual needle point could cause you personal injury.
4
Remove the top staple sheet.