Preparation 1 - Turning Power ON 33
To turn the equipment into the energy saving mode manually
Check that the equipment is in the ready status, and press the [ENERGY SAVER] button.
The equipment is now in the energy saving mode. The [ENERGY SAVER] lamp is lit.
Canceling conditions for energy saving mode
The energy saving mode is canceled under the following conditions. After the warm-up has been
completed, the equipment goes into the ready status.
Sleep mode
y When any of the buttons on the control panel is pressed
y When this equipment is connected to a PC with a USB cable
y When printing is performed from a PC connected with this equipment
y When the Platen Cover (optional) or the Automatic Document Feeder (optional) is raised
y When originals are placed on the Automatic Document Feeder (optional)
Super sleep mode
y When the [ENERGY SAVER] button on the control panel is pressed
y When this equipment is connected to a PC with a USB cable
y When printing is performed from a PC connected with this equipment
y When the Platen Cover (optional) or the Automatic Document Feeder (optional) is raised
To Next Page
Loading...
