Preparation 3 - Registering Size of Paper Placed 41
3
Press the [COPY] button several times until the lamp of the paper
size you placed in the drawer is lit.
If the [FUNCTION CLEAR] button is pressed at this step, the size is not registered and
the equipment will return to its normal status.
4
Press the [START] button.
The paper size has been registered.
Registering other standard sizes
When standard size paper other than A3, A4, A4-R, A5-R or B4 is placed, register this size as
“OTHER” size. Key in the code number of the paper size to register it as “OTHER” size.
See the table below for the code number of each size.
*1 ST-R and A5-R can be placed only on the bypass tray.
*2 13"LG size paper can be used only in equipment for the EU.
In this section, LT size is registered in the drawer of the equipment as an example.
1
Press and hold the [COPY] and [DRAWER] buttons simultaneously
for more than two seconds.
“Fnc” appears on the LED display.
Paper size Code No. Paper size Code No.
B5 05 LT-R 11
B5-R 06
ST-R
*1
12
LD 08 FOLIO 13
LG 09 COMP 14
LT 10
13"LG
*2
16
To Next Page
Loading...
