3 COPYING FUNCTIONS
56 Default Settings
Default Settings
Initial settings established when the equipment is powered on before any of the user functions
are changed are called default settings. Each setting returns to its default when the power is
turned ON, when the energy saving mode is canceled, and when the [FUNCTION CLEAR] but-
ton is pressed.
Each default setting of this equipment at the time of the installation is shown below.
*1 The automatic paper selection (APS) can be set only when the Automatic Document Feeder (optional) is
used.
If you need to change the default settings listed above, contact your service representative.
Item Contents Default setting at installation
Reproduction ratio 25 - 200% 100%
Copy quantity 1 - 999 1
Paper selection
Automatic paper selection (APS)
*1
,
Manual paper selection
Automatic paper selection (APS)
Density adjustment Automatic copy density mode, Manual
copy density mode
Automatic copy density mode
Image mode TEXT/PHOTO, PHOTO, TEXT TEXT/PHOTO
Sorting Non-sort copying, sort copying Non-sort copying
To Next Page
Loading...
