e-STUDIO2500c/3500c/3510c
To adjust the copy image quality
Use steps (a) through (i) to perform automatic calibration.
(a) Press the [USER FUNCTIONS] button on the Control Panel to enter the "User Functions" menu.
(b) Press the [ADMIN] button.
(c) Enter the 6 to 10 digit administrator password. Press the [ENTER] button.
(d) Press the [GENERAL] button.
(e) Press the [CALIBRATION] button.
(f) Press the [COPY] button.
(g) Press the [CALIBRATION] button to print out the test chart.
(h) Place the printed test chart on the original glass.
(i) Press the [START] button to perform calibration. When the calibration comes to an end, the message
"Scanning and calibrating" will disappear.
* As a result of the above steps, the copy image quality will be corrected in the Full Color mode and
Black and White mode simultaneously.
To adjust the print image quality
Use steps (a) through (j) to perform automatic calibration.
(a) Press the [USER FUNCTIONS] button on the Control Panel to enter the "User Functions" menu.
(b) Press the [ADMIN] button.
(c) Enter the 6 to 10 digit administrator password. Press the [ENTER] button.
(d) Press the [GENERAL] button.
(e) Press the [CALIBRATION] button.
(f) Press the [PRINT] button.
(g) Press the [CALIBRATION] button to print out the test chart.
(h) Place the printed test chart on the original glass.
(i) Press the [START] button to perform calibration. When the calibration comes to an end, the message
"Scanning and calibrating" will disappear.
(j) The message "Is a result made to reflect?" will appear. Press the [YES] button.
<Hint> During automatic calibration, the automatic image quality control option is also available. This
option is particularly recommended for a user who frequently adjusts the image quality.
However, performing this option increases each adjustment time.
Use steps (a) to (b) to perform automatic image quality control.
(a) Enter setting mode [08]. Set "1" for code [9059].
Value for 08-9059
Image quality control operation during
automatic calibration
0 OFF (default)
1 ON (with paper selection disabled)
2 ON (with paper selection enabled)
(b) Perform automatic calibration.
* Refer to the above procedure to perform automatic calibration.
* When the [COPY] button or [PRINT] button is pressed after step (f), image quality
control will be automatically performed.
After performing automatic calibration, print and check the image quality.
If further image quality adjustments are still necessary, use the next procedure.
1. General Adjustments – Copying, Printing and e-Filing (Output from Box)
1.1
To Next Page
Loading...
