e-STUDIO2500c/3500c/3510c
2.17 To Adjust the Image Quality Scanned from the RADF
Before the adjustment After the adjustment
The reproducibility of background may vary,
depending on how to scan an original.
The gap in the reproducibility of background
is reduced.
Explanation
The reproducibility of the background may vary, depending on the type of original, or whether the scanning is of
an original placed on the original glass or one fed from the RADF (MR-3018). Adjust the reproducibility of
background, while scanning an original fed from the RADF, in order to minimize the gap in the reproducibility
of the background, using either method of how to scan an original.
* Before performing this adjustment, make sure that the MFP and RADF are correctly adjusted. Therefore,
perform all the necessary adjustments. Only if further adjustment is still desired for the reproducibility of
background, should this adjustment be performed.
To scan an original placed on the original glass
To scan an original fed from the RADF
To scan an original placed on the original glass
To scan an original fed from the RADF
2. Copier-specific Adjustments
2.17
To Next Page
Loading...
