e-STUDIO2500c/3500c/3510c
PCL6 PS3 Mac
* This adjustment will have an effect only on Black and white mode printing.
(3) Enter adjustment mode [05]. Increase the value for code [7330] or [7335] to perform fine adjustment and
increase the sharpness intensity.
• Adjust the value for [05] code corresponding to the print option to be applied (PDL and Color mode).
* Printing on Macintosh is performed in PostScript. (See the "PS3" row in the table below.)
PDL Color mode [05] code Recommended value
Acceptable
value range
Default
PS3 Black and White 05-7330
PCL6 Black and White 05-7335
Set a value lager than 128 0 to 255 128
* Set the value in increments of approximately 5, while checking the printouts until the optimum value is
obtained.
<Note> This adjustment changes the values set in the MFP. Therefore, it will affect every user who uses
the printer by connecting it to the MFP. After the adjustment, the values changed will be applied
to all printouts for the "Sharpness" option. Carefully perform the adjustment, being aware that
the image quality of all future printouts will be changed, when printing out originals other than
the one that is used for the adjustment.
Precautions after the completion of the adjustment
The adjustment may possibly cause outlined edges, jaggies and variations in gradation. As a result the photo
image may look unnatural. Therefore, carefully perform the adjustment, while checking the printouts.
3. Printer-specific Adjustments
3.14
To Next Page
Loading...
