e-STUDIO2500c/3500c/3510c
PCL6 PS3 Mac
* This adjustment will have an effect only on Auto or Color mode printing.
(2) Enter adjustment mode [05]. To obtain a shaper or softer print image, change the values for codes
[8110/8114] to perform fine adjustment, and increase or decrease the sharpness intensity.
• Adjust the value for [05] code corresponding to the print option to be applied (PDL).
*Printing on Macintosh is performed in PostScript. (See the "PS3" row in the table below.)
PDL Color mode [05] code Recommended value
Acceptable
value range
Default
PS3 Twin color 05-8110
PCL6 Twin color 05-8114
Set a value larger than 128 to
obtain a sharper print image.
Set a value smaller than 128 to
obtain a softer print image.
0 to 255 128
* Setting "108" provides an effect corresponding to "-1" for the sharpness option. It is recommended to set
approximately "118" corresponding to an intermediate value between "0" (default) and "-1" for the
sharpness option, and then perform fine adjustment, while checking the printouts.
<Note> • This adjustment changes the values set in the MFP. Therefore, it will affect every user who
uses the printer by connecting it to the MFP. After the adjustment, the values changed will be
applied to all printouts for the "Sharpness" option. Carefully perform the adjustment, being
aware that the image quality of all future printouts will be changed, when printing out originals
other than the one that is used for the adjustment.
• The code in the Twin-color mode is commonly used in the Standard Auto/Color mode. After
the adjustment, the values changed will be also applied to the image quality in the Standard
Auto/Color mode. When adjusting the image quality in the Twin-color mode, carefully
perform the adjustment, being aware that the image quality of all future printouts will be
changed, when performing printing in the Standard Auto/Color mode.
3. Printer-specific Adjustments
3.24
To Next Page
Loading...
