2.16 To Adjust the Twin-Color Copy Image Quality
2.16.1 To Adjust the Tint of Colors other than Black
2.16.2 To Adjust the Reproducibility of Black in the Red and Black Mode
2.16.3 To Adjust the Boundary between Black and Colors other than Black
2.17 To Adjust the Image Quality Scanned from the RADF
3. Printer-specific Adjustments
3.1 To Maintain a Steady Color Balance
3.2 To Maintain a Steady Color Balance on Thick Paper or Special Paper
3.3 To Obtain the Desired Color Balance
3.4 To Closely Match the Color Balance on the Monitor
3.5 To Maintain a Uniform Gray Hue
(To maintain Consistency in Gray among Text, Photos and Graphics)
3.6 To Use Only the Black Toner to Reproduce Gray Areas
(To use only the black toner to reproduce black-and-white photos or gradational images)
3.7 To Easily Adjust the Overall Brightness
3.8 To Adjust the Overall Saturation
3.9 To Easily Adjust the Overall Contrast
3.10 To Obtain a Sharper Print Image
3.11 To Obtain a Softer Image
3.12 To Make Low-resolution Data Look Finer (To soften an image)
3.13 To Eliminate Smudges from Highly Colored Text and Lines
(To prevent toner scattering around text and lines where a large amount of toner is used)
3.14 To Clearly Print Light-Colored Thin Lines or Text
3.14.1 To Adjust the Print Image Quality in the Color Mode
3.14.2 To Adjust the Print Image Quality in the Black and White Mode
3.15 To Make the Light-Colored Area Darker on the Printout
3.16 To Clearly Print Thin Lines/Double Lines
3.17 To Decrease the Image Density and Save Toner (To Print in the Toner Save Mode)
3.18 To Adjust the Image Density in the Toner Save Mode
3.19 To Print Illegible Gray or Colored Text in Black
3.20 To Ignore Blank Pages for Printing
3.21 To Sharply Print Black Text
3.22 To Prevent Dark Toner from Coming Off
3.23 To Register the Image Quality Adjusted Corresponding to a Preference
(To use the Custom Color Settings)
3.24 To Print a Full-Color Original in Two Colors
Table of Contents
ii
To Next Page
Loading...
