e-STUDIO2500c/3500c/3510c
(4) Enter adjustment mode [05]. Change the values for codes [604/605], [1737 to 1741] and [1757] to adjust
the sharpness intensity.
* Decreasing the sharpness intensity will minimize the edges of the image.
Color mode Original mode [05] code Recommended value
Acceptable
value range
Default
Text/Photo 05-604
Black
Text 05-605
Set a value smaller than 128. 0 to 255 128
Text/Photo 05-1737
Text 05-1738
Printed image 05-1739
Photo 05-1740
Full color
Map 05-1741
Set a value smaller than 128. 0 to 255 128
Auto color Text/Photo 05-1757 Set a value smaller than 128. 0 to 255 128
* Setting "0" provides the softest image, while setting "255" provides the sharpest image.
Changing the values for these codes will change the sharpness intensity, when the "Sharpness" indicator in
the "IMAGE" menu is set to the center. Remember that 1 step of the indicator will increase or decrease the
sharpness intensity by 25. If the sharpness intensity of the center value is changed, each step of the indicator
will be changed accordingly. (For instance, if the center value is decreased by 25 (softer), the value of each
step of the indicator will also be decreased by 25 (softer).)
* The value adjusted for the sharpness intensity is shared in the Full color mode with the Printed image
mode selected and in the Black mode with the Photo mode selected. Therefore, adjusting the copy image
quality in either of the modes affects that in the other mode. Perform copy image quality adjustment in the
mode that is used for the adjustment, while checking that in the other mode.
<Note> "Minimizing the edges of the copy image" and "Sharpening the copy image" are mutually
contradictory. When the adjustment is performed to minimize the edges, the resolution of the
copy image may decrease.
After decreasing the sharpness intensity, copy and check the copy image quality.
If further image quality adjustments are still necessary, use the next procedure.
(5) Enter adjustment mode [05]. Change the values for codes [1630 to 1633] to adjust the maximum color
density of text.
Color to adjust
[05] code Recommended value
Acceptable
value range
Default
Y
(Yellow)
05-1630
M
(Magenta)
05-1631
C
(Cyan)
05-1632
K
(Black)
05-1633
Set a value larger than 5 to
increase the density.
Set a value smaller than 5 to
decrease the density.
0 to 10 5
* Set the value in increment of 1, while checking the copy image until the optimum value is obtained.
After adjusting the maximum color density of the text, copy and check the copy image quality.
If further image quality adjustments are still necessary, use the next procedure.
2. Copier-specific Adjustments
2.10
To Next Page
Loading...
