e-STUDIO2040C/2540C/3040C/3540C/4540C © 2011 TOSHIBA TEC CORPORATION All rights reserved
2 - 72
2. Copier-specific Adjustments
(2) Enter the adjustment mode [05]. Change the values for codes [7025], [7075] to [7764] or [7766] to adjust
the reproducibility of the background when using the RADF.
Color mode Original mode [05] code
Recommended
value
Acceptable
value range
Default
Full Color / Auto color
(when judged as color)
ALL 05-7764
Text/Photo Auto color
(when judged as black)
Text
05-7675
Text/Photo
Text
User custom
05-7025
Photo
Black
Image
smoothing
Mono color ALL
05-7765
Twin Color ALL 05-7766
Set 128 or larger. 0 to 255 128
* Set the value in increments of approximately 20, while checking the copy image until the optimum value is
obtained.
Precautions after the completion of the adjustment
Correctly adjusting the installation heights of the MFP and the RADF is a prerequisite to perform this adjustment.
Therefore, perform all the necessary adjustments. Only if further adjustment is still desired for the reproducibility of
background, should this adjustment be performed.
To Next Page
Loading...
