e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C © 2011 TOSHIBA TEC CORPORATION All rights reserved
6 - 1
6. Printer-specific Adjustments (GA-1211)
6.1 To Maintain a Steady Color Balance (Calibration)
Before the adjustment After the adjustment
The color balance varies according to a
change in the environment or a lapse of time.
The color balance is constantly maintained.
Explanation
Color balance varies with a change in the use environment, replacement of the consumables and so forth.
Therefore a periodic adjustment of the color reproducibility (calibration) is needed in order to maintain a steady
color balance on printouts.
“Calibration” in this section indicates that calibration for both a printer engine in the MFP and the Fiery Printer
Controller (GA-1211). Calibration is a basic adjustment to accurately reproduce colors on printouts. If you would
like to accurately reproduce the intended hue or when you have replaced consumables or changed the installation
environments, be sure to perform calibration to ensure the accurate color reproducibility.
To Next Page
Loading...
