e-STUDIO2040C/2540C/3040C/3540C/4540C © 2011 TOSHIBA TEC CORPORATION All rights reserved
3 - 57
3. Printer-specific Adjustments
* This adjustment will have an effect only on Black and white mode printing.
(2) Enter adjustment mode [05]. Increase the values for codes [7315 to 7320] to adjust the gamma curve
balance and increase the density on Black and White mode printing.
• Adjust the value for [05] code corresponding to the print option to be applied (PDL and Halftone).
* Printing on Macintosh is performed in PostScript. (See the "PS3" row in the table below.)
PDL Halftone [05] code Subcode
Recommen
ded value
Acceptable
value range
Default
Smooth 05-7315 0/1/2
Detail 05-7316 0/1/2
Automatic (Text) 05-7360 0/1/2
Automatic (Graphics) 05-7361 0/1/2
PS3
Automatic (Image) 05-3762 0/1/2
Smooth 05-7317 0/1/2
Detail 05-7318 0/1/2
Automatic (Text) 05-7363 0/1/2
Automatic (Graphics) 05-7364 0/1/2
PCL6
Automatic (Image) 05-7365 0/1/2
Smooth 05-7319 0/1/2
Detail 05-7320 0/1/2
Automatic (Text) 05-7365 0/1/2
Automatic (Graphics) 05-7366 0/1/2
XPS
Automatic (Image) 05-7367 0/1/2
Set a value
larger than
128
0 to 255 128
* Set the value in increments of approximately 10, while checking the printouts until the optimum value is
obtained.
* When the halftone is set to "Auto", the gamma balance can be adjusted for every print data format (Text,
Graphic and Image).
* The subcode varies according to the area where the density is adjusted. Refer to the table below and set
the subcode for the area to be adjusted.
* Whether to fix or change the maximum density in a high-density area can be selected by the setting of 05-
8066.
Subcode Area where the density is adjusted Notes
0 Low-density area
1 Medium-density area
2
High-density area 0: The maximum color density in a
high-density area is fixed.
1: The maximum color density in a
high-density area is changed.
<Note> • This adjustment changes the values set in the MFP. Therefore, it will affect every user who
uses the printer by connecting it to the MFP. After the adjustment, the values changed will be
applied to all printouts for the "Halftone" option. (For instance, if the value for [05] code for PCL
and Detail is changed, it will be applied to printing performed with PCL6 and Halftone = "Detail"
(or "Auto") selected.) Carefully perform the adjustment, being aware that the image quality of all
future printouts will be changed, when printing out originals other than the one that is used for the
adjustment.
PCL6 PS3 Mac XPS
To Next Page
Loading...
