Toshiba e-studio 2540c - Page 212

e-STUDIO2040C/2540C/3040C/3540C/4540C © 2011 TOSHIBA TEC CORPORATION All rights reserved
3 - 85
3. Printer-specific Adjustments
* This adjustment will have an effect only on Black and white mode printing.
(6) Enter adjustment mode [05]. Change the values for codes [8042 to 8065] to adjust the color density (Color balance).
• Adjust the value for [05] code corresponding to the print option to be applied (PDL and Halftone).
Ex.: • When printing on Windows is performed with the following options selected: PCL6, Image Quality
Type = General, Halftone = Auto
> Text area, graphic area and image area
Change the values for Y: 05-8058, M: 05-8059, C: 05-8060 and K: 05-8061.
• When printing on Macintosh is performed with the following option selected: Image Type =
Photograph, Halftone = Smooth
> Change the values for Y: 05-8050, M: 05-8051, C: 05-8052 and K: 05-8053.
* Printing on Macintosh is performed in PostScript. (See the "PS3" row in the table below.)
* The hue of the black text printed using all color toners (C, M, Y and K) will look much clearer, if the amount
of the C (cyan) toner used is larger than the M (magenta) or Y (yellow) toner. Remember that adjusting the
density of K (black) does not affect the hue of the black text, if all color toners are used to print the text.
Color to
adjust
PDL Halftone [05] code Subcode
Recommended
value
Acceptable
value
range
Default
Smooth 05-8058 0/1/2
PCL6
Detail 05-8062 0/1/2
Smooth 05-8050 0/1/2
PS3
Detail 05-8054 0/1/2
Smooth 05-8042 0/1/2
Y
(Yellow)
XPS
Detail 05-8046 0/1/2
Smooth 05-8059 0/1/2
PCL6
Detail 05-8063 0/1/2
Smooth 05-8051 0/1/2
PS3
Detail 05-8055 0/1/2
Smooth 05-8043 0/1/2
M
(Magenta)
XPS
Detail 05-8047 0/1/2
Smooth 05-8060 0/1/2
PCL6
Detail 05-8064 0/1/2
Smooth 05-8052 0/1/2
PS3
Detail 05-8056 0/1/2
Smooth 05-8044 0/1/2
C
(Cyan)
XPS
Detail 05-8048 0/1/2
Smooth 05-8061 0/1/2
PCL6
Detail 05-8065 0/1/2
Smooth 05-8053 0/1/2
PS3
Detail 05-8057 0/1/2
Smooth 05-8045 0/1/2
K
(Black)
XPS
Detail 05-8049 0/1/2
Set a value larger
than 128.
0 to 255 128
* Set the value in increments of approximately 20, while checking the printouts until the optimum value is
obtained.
PCL6 PS3 Mac XPS