112
3.SETTING OF BASIC COPY MODES
4.Selecting Finishing Modes (Cont.)
3
Manual stapling (MJ-1101 only)
The manual stapling function which enables you to use the staple function without making copies is avail-
able in the Finisher (MJ-1101, optional). This function is useful when copies are made without stapling
being set or when you want to staple originals.
A: Stapling position lamps C: Manual-stapling lamp
B: [Stapling position] button D: [Manual-stapling] button
1
Press the [Manual-stapling] button.
The shutter in the paper exit area is opened.
2
Press the [Stapling position] button to switch the stapling position.
Stapling positions are the front and the other end.
The stapling position lamp corresponding to the selected stapling position lights in green.
3
Place paper in the lower tray of the finisher.
Jog the paper well and place it with its face down.
Place the paper in front to have it stapled in the front, and in the other end to have it stapled in the
other end.
Check that the manual-stapling lamp lights in green. If not, place the paper again.
4
Release the paper and press the [Manual-stapling] button.
The stapling position lamp blinks when the stapling is completed. Remove the paper.
Be sure to release the paper before the manual stapling.
A C DB
To Next Page
Loading...
Need help?
General
