219
7
7
Press the [NAME1] button and the [NAME2] button, and then enter the
template name.
• [NAME 1] is displayed in the upper side and [NAME 2] is displayed in the lower side of the template button.
Enter [NAME 1] and/or [NAME 2]. When both are entered, [NAME 1] is displayed in the upper side and [NAME
2] is displayed in the lower side of the button.
• When the [NAME 1] or [NAME 2] button is pressed, the letter entry menu ( P.35) is displayed. Up to 11 let-
ters can be entered.
• The following symbols cannot be used for [NAME 1] and [NAME 2].
["], [=], [|], [*], [<], [>], [?], [+], [[], []], [;], [:], [/], [\], [,], [.]
8
Press the [USER NAME] button, and then enter the user name of the
template as required.
• When the [USER NAME] button is pressed, the letter entry menu ( P.35) is displayed. Up to 30 letters can
be entered.
• To set the password, proceed to step 9. If not, skip to step 11.
To Next Page
Loading...
