4 SCAN FUNCTIONS
120 Scan Settings
Character entry
The character entry screen is for entering characters when you are setting and entering items.
You can enter the following:
Alphabet characters, numbers and symbols.
Enter the characters using the digital keys and , , , or , after switching the type of the character with the [✱] digital
key.
Switching the input mode
The type of the character is displayed in the first line of the message display panel. Set the type of character to enter by
pressing the [✱] digital key.
The input mode switches as follows each time the [✱] key is pressed.
Alphabet characters <--> Numbers
Entering characters
Example: To enter “Chicago”
1
Press [✱] to set the alphabet input mode.
2
Press [2] a few times to enter “C”.
3
Press to move the cursor to the right.
If you want to enter the character assigned to another digital key, you can enter it without moving the cursor to
the right or pressing .
4
Similarly, you can enter the following characters using the digital keys.
5
After you have entered the last character, Press [OK].
To Next Page
Loading...
Need help?
General
