1 PREPARATION
26 Preparation 2 - Loading Paper
5
While pushing the green knob of the side guides, adjust the side guides at the position
of the desired paper size.
Adjust the side guides with both hands.
6
Load paper face up in the drawer.
Up to 550 sheets (80 g/m
2
or 20 lb. Bond) can be loaded. Be sure that the height of the stacked paper does
not exceed the line indicated inside of the guide.
P.20 “Acceptable paper types”
Fan the paper well before loading it in the drawer, otherwise multiple feeding could occur. Be careful not to
cut your fingers.
Place the paper face up. The printable side may be noted on its packaging.
7
Adjust the side guides.
Be sure that a gap of approx. 0.5 mm (0.02") (1.0 mm (0.04") or less in total) is left between the paper and each
side guide (shown as “A” in the picture). If the gap is inappropriate, this could cause a paper misfeed.
To Next Page
Loading...
Need help?
General
