2.COPY FUNCTIONS
Copy Settings 51
2 COPY FUNCTIONS
4
Follow the instructions on the LCD screen to use the “2IN1/4IN1” function. You are
instructed to make the following settings.
ORIGINAL SIZE
Press or to select the size of the original.
ORIGINAL ORIENTATION
Press or to select the portrait or landscape orientation of the original.
SET ORIGINAL
Place the originals as shown on the LCD screen. Make sure that you place the original in the same orientation
as the one selected in “ORIG. ORIENTATION”.
NEXT ORIGINAL?
When you place the original on the original glass, this message appears. Press or to select “SCAN NEXT
PAGE”. Select “FINISHED” when you have finished scanning your originals.
The size of the original selected in [ORIGINAL SIZE] is disabled if it is detected automatically.
For the detectable original sizes, see the following page:
P.34 “Acceptable originals”
If the size of the original is not detected automatically, specify [ORIGINAL SIZE] and place the original on
the original glass.
“CANCEL JOB?” is displayed if there is no operation for a certain period.
To Next Page
Loading...
Need help?
General
