3
© 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO200L/202L/203L/230/232/233/280/282/283
COPY PROCESS
3 - 13
3.3 Comparison with e-STUDIO350/450
Process e-STUDIO350/450
e-STUDIO200L/202L/203L/230/230L/
232/233/232S/280/280S/282/283/
282S/283S
1. Photoconductive drum
• Sensitivity
• Surface potential
OD-3500 (OPC ø60)
Highly sensitized/durable drum
-750 V
OD-1600 (OPC ø30)
-475 V
2. Charging
• Grid voltage
Scorotron method
-790 V
-495 V
3. Data writing
•Light source
• Light amount
Semiconductor laser (Adjustment not
required)
4.3 nJ/mm
2
4.0 nJ/mm
2
4. Development
• Magnetic roller
• Auto-toner
• Toner supply
• Toner-empty detection
• Toner
• Developer material
• Developer bias
One magnetic roller
Magnetic bridge-circuit method
Toner cartridge
Density detection method
T-3520, T-3520E, T-3520D, T-3520C,
T-3520T
D-3500, D-3500C
DC-550 V Adjustable output (during
printing)
DC+150 V Fixed (others)
T-2320, T-2320E, T-2320D, T-2320C,
T-2320T (e-STUDIO200L/230/230L/
280/280S)
T-2340, T-2340E, T-2340D, T-2340C,
T-2340T (e-STUDIO202L/232/232S/
282/282S)
T-2840, T-2840E, T-2340C
(e-STUDIO203L/233/283/283S)
D-2320, D-2320C
DC-357 V Adjustable output
(during printing)
AC 1100 V (Adjustment not required,
during printing)
5. Transfer
• Transfer bias
Adjustable output (Constant current)
+580 V (Adjustment not required)
+600 V (Adjustment not required)
6. Separation AC: Adjustable output
(Constant voltage)
DC: Adjustment not required
7. Discharge
• Discharging position
• Discharge LED
Exposure after cleaning
Red LED
8. Cleaning
• Method
• Recovered toner
Cleaning blade
Not reusable
Reuse (There is the recovered toner
supply mechanism.)
9. Fusing
• Method
• Cleaning
•Heater
Long-life fuser roller method
Fuser roller:
Thin roller coated with fluoroplastic
(ø40)
Pressure roller:
PFA tube roller (ø30)
Cleaning roller for pressure roller (ø14)
IH coil (Induction-heating method)
Turned ON/OFF by thermistor
Thin roller coated with fluoroplastic
(ø30)
Cleaning roller for pressure roller (ø16)
Heater lamp
07/11