Toshiba e-STUDIO200L/230/280 SERIES - Disassembly and Replacement

9
© 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO200L/202L/203L/230/232/233/280/282/283
PAPER FEEDING SYSTEM
9 - 13
9.4 Disassembly and Replacement
[A] Bypass pickup roller
[B] Bypass feed unit
(1) Remove 1 clip.
(2) Pull out the shaft and take off the bypass
pickup roller.
Fig. 9-9
(1) If the ADU is not installed, take off the right
front hinge cover, the right rear hinge cover
and the bypass upper cover ( P.2-38 "[P]
Right front hinge cover",  P.2-39 "[Q] Right
rear hinge cover",  P.2-39 "[R] Bypass
upper cover").
If the ADU is installed, take off the ADU (
P.15-10 "[A] Automatic Duplexing Unit
(ADU)").
(2) Remove 1 spring.
(3) Disconnect the connector of the bypass feed
clutch.
Fig. 9-10
Clip
Shaft
Bypass pickup roller
Spring
Connector
04/09