Toshiba e-STUDIO200L/230/280 SERIES - Disassembly and Replacement

10
© 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO200L/202L/203L/230/232/233/280/282/283
DRIVE SYSTEM
10 - 5
10.4 Disassembly and Replacement
[A] Main motor
[B] Main motor drive unit
(1) Take off the SYS board case
( P.2-46 "[D] SYS board case").
(2) Disconnect 1 connector. Remove 2 screws,
release 2 locking support, and then take off
the main motor.
Fig. 10-3
(1) Take off the process unit
( P.11-8 "[A] Process unit").
(2) Take off the SYS board case
( P.2-46 "[D] SYS board case").
(3) Take off the connecting port cover
( P.2-37 "[O] Connecting port cover").
(4) Remove 1 screw and take off the flywheels.
Fig. 10-4
Screw
Screw
Connector Main motor
Flywheel