e-STUDIO200L/202L/230/232/280/282 ADJUSTMENT June 2004 © TOSHIBA TEC
3 - 54
(4) Remove the stepped screw at the rear of
right-hand hinge.
Fig.3-53
(5) Open the RADF, and then loosen 2 hand
screws 1 turn (status of tentative fixing).
Fig.3-54
(6) Remove the positioning pin at the front side.
Close the RADF to fit the positioning pin into
the hole at the rear side of the RADF. While
peering inside from the front side, fit the posi-
tions of the pin and hole by moving the
RADF right and left.
Fig.3-55
Screw
To Next Page
Loading...
