292
9.BLINKING GRAPHIC SYMBOLS
4.Jam Symbols (Cont.)
9
5
Close the offset tray cover or job separator cover. Close the fuser unit
cover and the jam releasing cover. Return the automatic duplexer and
bypass tray to the original positions.
Releasing a paper misfeed in the Bridge Unit (optional)
3
Close the Bridge unit cover.
4
Remove any misfed paper inside the off-
set tray unit or job separator unit.
1
Holding the cover handle of the Bridge
Unit, open the cover.
2
Remove any misfed paper that is inside
the Bridge Unit.
• Remove the misfed paper from the fuser unit side if it is easier.
To Next Page
Loading...
