304
10.WHEN THIS MESSAGE APPEARS
1.“Check staple cartridge” (Cont.)
10
7
Install the finisher to the equipment.
Be careful not to let your fingers be caught between the equipment and the finisher (optional). This could injure
you.
3
Take the empty staple case out of the sta-
ple cartridge.
4
Install a new staple case into the staple
cartridge.
• Insert the new case into the cartridge until you hear a click
sound.
• Do not remove the seal bundling the staples until the new staple
case is installed into the cartridge.
5
Remove the seal bundling the staples
and then pull out the seal straight
upward.
6
Install the staple cartridge into the sta-
pler.
• Insert the cartridge until it is caught by the latch and fixed with a
click sound.
If “Check staple cartridge” remains, repeat the above procedure
from steps 1 to 6.
To Next Page
Loading...
