e-STUDIO200L/202L/230/232/280/282 ADJUSTMENT June 2004 © TOSHIBA TEC
3 - 70
[B] Adjustment
If the pins cannot be fitted into the holes, perform the adjustment according to the following procedure.
(3) Close the RADF and check if the positioning
pins fit the holes on the RADF.
Fig.3-81
(1) Remove the right-hand hinge screw at the
rear side.
Fig.3-82
(2) Loosen the left-hand hinge screw at the rear
side.
Fig.3-83
05/11
To Next Page
Loading...
