Toshiba e-STUDIO230 - Page 367

June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 ADJUSTMENT
3 - 71
3
(3) Loosen the hinge screws at the front side.
Fig.3-84
(4) Position the pins with the holes on the RADF
by moving it so that the pins fit into the holes
when the RADF is closed.
Fig.3-85
(5) Tighten the left-hand hinge screw at the rear
side.
Fig.3-86
05/11