June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 TROUBLESHOOTING
5 - 69
5
[CC50] Horizontal registration motor abnormality
MJ-1025
Is the horizontal registration home position sensor (PI2P) working properly?
#
NO Replace the sensor.
YES
Is the wiring between the finisher controller PC board and the horizontal registration home
position sensor (PI2P) correct?
#
NO Correct the wiring.
YES
Is there any problem with the horizontal registration mechanism?
#
YES Fix the mechanism.
NO
Replace the horizontal registration motor (M2P).
Try replacing the punch controller PC board. Is the problem corrected?
#
YES End.
NO
Replace the finisher controller PC board.
[CC60] Punch motor abnormality
MJ-1025
Is the punch home position sensor (PI1P) working properly?
#
NO Replace the sensor.
YES
Is the punch motor clock sensor (PI3P) working properly?
#
NO Replace the sensor.
YES
Is the wiring between the finisher controller PC board and sensor correct?
#
NO Correct the wiring.
YES
Is there any problem with the punching mechanism?
#
YES Fix the mechanism.
NO
Replace Punch motor (M1P)
Try replacing the punch controller PC board. Is the problem corrected?
#
YES End.
NO
Replace the finisher controller PC board.
To Next Page
Loading...
