e-STUDIO200L/202L/230/232/280/282 TROUBLESHOOTING June 2004 © TOSHIBA TEC
5 - 70
[CC80] Front jogging plate motor abnormality/Alignment motor (front) abnormality
MJ-1022 (Front jogging plate motor abnormality)
Is the front jogging plate home position sensor (S6) working properly?
#
NO Replace the sensor.
YES
Is the wiring between the finisher controller PC board and front jogging motor (M3) correct?
#
NO Correct the wiring.
YES
Has the rack run over the stopper of the roll?
#
YES Fix it.
NO
1) Replace the front jogging motor.
2) Replace the finisher controller PC board.
MJ-1025 (Alignment motor (front) abnormality)
Is the aligning plate home position sensor (front) (PI4) working properly?
#
NO Replace the sensor.
YES
Is the wiring between the finisher controller PC board and alignment motor (front) (M4) cor-
rect?
#
NO Correct the wiring.
YES
Is there any mechanical problem with the path of aligning plate?
#
YES Fix the mechanism.
NO
Try replacing the alignment motor (front) (M4). Is the problem corrected?
#
YES End.
NO
Replace the finisher controller PC board.
To Next Page
Loading...
