3 INSTALLING PRINTER DRIVERS FOR WINDOWS
44 Installing the Printer Drivers
6
Configure the printer port.
The procedure for configuring the printer port varies depending on the connection. Go to the steps
suited to your connection.
P.44 “Raw TCP/LPR printing”
P.57 “SMB printing”
P.59 “Novell printing”
Raw TCP/LPR printing
Configure the Raw TCP/LPR port as described in the following procedure.
Confirm the following before starting the configuration:
- This equipment is connected to the network and turned on.
- The TCP/IP setting is correct on this equipment and your computer.
Searching your TOSHIBA MFP automatically
This equipment is automatically discovered over the network. Then you can install printer driver so as to
configure the Raw TCP/LPR port.
If this equipment is not discovered over the network after the installation is started, a dialog box indicating
this appears. Follow the procedure below to continue the configuration.
- To search this equipment over the network again, click [Retry].
- Confirm the SNMP settings specified in the [SNMP Settings] dialog box.
- To select a temporary local port and then configure the Raw TCP/LPR port, click [Continue]. Then
follow the procedure as described in the following page:
P.46 “If your TOSHIBA MFP is not found”
- If you know the IP address of this equipment, you can specify a printer port with the direct entry from
the keyboard. In step 7, enter a network path shown below in [Selected printer port].
\\IP_<IP address>
7
A list for the discovered printers is displayed. Then select this equipment on the list
and then click [OK].
The TCP/IP port is created.
To Next Page
Loading...
Need help?
General
