2.PRINTING FROM WINDOWS APPLICATIONS
36 Setting the Layout and Finishing Options
Changing Margins
Sets the margins for pages. You can usually set margins in the application you are using. Use this option if you cannot
make settings from the application.
When [Booklet] is selected from [2-Sided Printing], this option is unavailable.
This cannot be used to specify the binding margin for Booklet printing.
1
Display the [Finishing] tab menu.
2
Select [Use Custom Margin], and then click [Details].
3
Set the margins as needed, and then click [OK].
Extend Printing Area: Select to extend the printing area.
This equipment does not support borderless printing. Some parts are not printed to the edges even if you specify
margins to 0 mm due to the restrictions on this equipment.
Margin: Enter a value between 4.2 to 100 mm.
Units: Select the unit of measurement from [mm] or [inch].
Restore Defaults: Restores the [Custom Margin] settings to their defaults.
4
Set other printing functions as needed, and then click [OK].
5
Click [Print] or [OK] to send the job.
The following printing areas are applied if you specify margins to 0 mm.*
e-STUDIO5005AC Series: 4.2 mm from the top, 3.5 mm from the bottom, and 2.0 mm from left and right edges.
e-STUDIO5008A Series: 4.0 mm from the top, 2.5 mm from the bottom, and 2.0 mm from left and right edges.
* Excluding paper sizes [305 x 457 mm], [320 x 450 mm], [320 x 460 mm], and [13 x 19"].
To Next Page
Loading...
