2.Copier-specific Adjustments
© 2018 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
2-58
(4) Select [05 ADJUSTMENT MODE]. Change the setting values for codes [7960], [7961], [7965],
[7966], [7970], [7971], [7975], [7976] and [7980] to [7983] to adjust the density for each color.
• Set the value in increments of approximately 10, while checking the copy image until the optimum
value is obtained.
• The setting value “25” corresponds to one step in the adjustment on the control panel.
• The subcode varies according to the area where the density is adjusted. Refer to the table below
and set the subcode for the area to be adjusted.
Caution after the adjustment
The adjustment may possibly cause a dark-colored area, such as in a photo, to become blurred on the
copy. Also, it may also cause offset failure, grained images and degradation in gradation. Therefore,
carefully perform the adjustment, while checking the copy image.
Original
mode
Color to
adjust
[05] code Subcode
Recommended
value
Acceptable
value range
Default
Text/Photo
Y (Yellow) 05-7960 0/1/2
Set a value larger
than 128.
0 to 255 128
M (Magenta) 05-7965 0/1/2
C (Cyan) 05-7970 0/1/2
K (Black) 05-7975 0/1/2
Text
Y (Yellow) 05-7961 0/1/2
M (Magenta) 05-7966 0/1/2
C (Cyan) 05-7971 0/1/2
K (Black) 05-7976 0/1/2
User Custom
Y (Yellow) 05-7980 0/1/2
M (Magenta) 05-7981 0/1/2
C (Cyan) 05-7982 0/1/2
K (Black) 05-7983 0/1/2
Red Seal
Color
Y (Yellow) 05-7984 0/1/2
M (Magenta) 05-7985 0/1/2
C (Cyan) 05-7986 0/1/2
K (Black) 05-7987 0/1/2
Subcode Area where the density is adjusted
0 Low density area
1 Middle density area
2 High density area
To Next Page
Loading...
