3.Printer-specific Adjustments
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC © 2018 TOSHIBA TEC CORPORATION All rights reserved
3-44
3.4.2 To Closely Match the Color Balance on the Monitor
Explanation
The color balance on the printouts is initially programmed to provide the maximum color saturation within
the range of colors reproducible in printing. In general, colors, which can be reproduced, vary, depending
on whether they are reproduced on the printout or on the monitor (or depending on whether they are
reproduced in “ink” or with the “light”). Consequently, the color balance on the printout cannot be
perfectly matched with the one on the monitor. Change the “Image Quality Type” option, in order to
closely match the color balance on the printout with the one on the monitor, at a user’s request.
• This adjustment will be effective in closely matching the color balance on the printout with the one on
the monitor, if the sRGB is selected as a color space. Therefore, remember that it may not be matched
with the color balance on the monitor, which does not support sRGB or if a color space other than
sRGB is selected.
On commercially available monitors, sRGB is not selected as a color space by default.
As viewed on the monitor
Before adjustment After adjustment
The color balance as viewed on the
monitor looks different from the printout.
The color balance of the printout is
closely matched with the one on the
monitor
To Next Page
Loading...
