2.Copier-specific Adjustments
© 2018 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
2-60
Procedures
• You can start with any of the procedures. But it is recommended to perform the procedures in order, as
listed below. You can perform one procedure in conjunction with another. But if this changes the image
quality more than required or loses the effectiveness of the adjustment, restore the settings made in
the previously performed procedure to the original ones. Then perform other procedures.
• Both the service technician and the user can perform procedures (1) and (3).
• Only the service technician must perform procedures (2) and (4).
(1) Press [Image] tab on the Copy mode. Press [One Touch Adjustment].
Press [Maker].
After selecting the “Marker” option, copy and check the copy image quality.
When the copy image quality with the “Marker” option is insufficient, cancel the “Marker” option and
perform the next procedure. (The one-touch adjustment can be canceled by pressing [One Touch
Adjustment] again.)
(2) Select [05 ADJUSTMENT MODE]. Change the value for code [7850] to adjust the tint of colors in
Marker mode.
• Set the value in increments of approximately 1, while checking the copy image until the optimum
value is obtained.
• The subcode varies according to the color where the adjustment is performed. Refer to the table
below and set the subcode for the color to be adjusted.
• Setting a value larger than the default value moves the hue of the color selected to [+] as shown
below. On the other hand, setting a value smaller than the default value moves it to [-].
(For instance, set “6” for R (Red). Then the tint of the red is closely matched with that of Y
(Yellow). Set 0 for R (Red). Then the tint of the red will be closely matched with that of M
(Magenta).
After adjusting the hue, copy and check the copy image quality.
If further image quality adjustments are still necessary, perform the next procedure.
[05] code Subcode Acceptable value range Default
05-7850 0 to 5 0 to 6 3
Subcode Color to adjust
0 Y (Yellow)
1 M (Magenta)
2 C (Cyan)
3R (Red)
4 G (Green)
5B (Blue)
To Next Page
Loading...
