3.Printer-specific Adjustments
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC © 2018 TOSHIBA TEC CORPORATION All rights reserved
3-6
You can also change the range of the color to be printed in only the K toner.
When “Text, Graphic & Image” is selected for the “Apply to” setting on the printer driver setting
menu, photo areas whose colors are close to black may be treated as black because the larger the
value is, the wider the area to be printed only with K toner becomes. Therefore, adjust the value
carefully while checking the copied image.
If black lines created by the graphic are still reproduced by 4 colors even after this adjustment has
been performed, change the settings of the application and reattempt printing.
When an illustrator is used, select [File] > [Document Setting] > [Custom] and then set to the value
to “Vector” in the Rasterization and Vector Balance option.
Caution after the adjustment
Nothing in particular
PDL
Original
mode
[05] code Subcode Recommended value
Acceptable
value range
Default
PS
Text 8252 0/1/2/3/4
The larger the value,
the wider the area to
be replaced with that
for printing with only
black toner becomes.
The smaller the value,
the smaller the area to
be replaced with that
for printing with only
black toner becomes.
1 to 255 8/8/8/8/8
Graphic 8253 0/1/2/3/4 1 to 255 1/1/1/8/1
Image 8254 0/1/2/3/4 1 to 255 1/1/1/8/1
PCL
Text 8210 0/1/2/3 1 to 255 8/8/8/8
Graphic 8211 0/1/2/3 1 to 255 1/1/1/8
Image 8212 0/1/2/3 1 to 255 1/1/1/8
XPS
Text 8249 0/1/2/3/4 1 to 255 8/8/8/8/8
Graphic 8250 0/1/2/3/4 1 to 255 1/1/1/8/1
Image 8251 0/1/2/3/4 1 to 255 1/1/1/8/1
Subcode Image Quality Type
0 General
1 Photograph
2 Presentation
3Line Art
4 Advanced
To Next Page
Loading...
