1.General Adjustments – Copying, Printing and e-Filing (Output from Box)
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC © 2018 TOSHIBA TEC CORPORATION All rights reserved
1-42
(4) (c) Fine image position adjustment
Adjust the image position finely in order to shift the image on both sides to the optimal positions.
Refer to the procedure “(2)-(a) Image position adjustment”.
Images may slightly deviate from the correct writing start position; however, the entire amount of the
deviation between image positions on both sides is reduced.
Precautions after the completion of the adjustment
It is very difficult precisely to match the image positions on the front and back sides. The deviation
amount will not be “0”, if minor deviations occurring during continuous printing are included. However,
the amount of the deviation between the front and back sides can be reduced to approximately 0.5 mm
to 1.5 mm by using this adjustment.
Before adjustment After adjustment
The center of the image may have a deviation.
Suppress the deviation in the center.
To Next Page
Loading...
