2.Copier-specific Adjustments
© 2018 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
2-29
(2) Select [05 ADJUSTMENT MODE]. Change the values for the following codes below to adjust the
density level of the background.
• The highlighted area will become highly visible, if the background density is increased.
• Set the value in increments of approximately 10, while checking the copy image until the optimum
value is obtained.
<Note>
• “Making the highlighted area more visible (or increasing the background density)” and “eliminating
the background color (or decreasing the background density)” are mutually contradictory. If the
background color is darkened to make the highlighted area more visible, the hue of the
background may change.
After adjusting the background density, copy and check the copy image quality.
If further image quality adjustments are still necessary, perform the next procedure.
(3) Press [Copy] on the [Home] screen. Press [ ] to increase the copy density.
After increasing the copy density, copy and check the copy image quality.
With the copy density set to the maximum, if further image quality adjustments are still necessary,
the service technician must perform the next procedure.
Color mode Original mode [05] code Recommended value
Acceptable
value range
Default
Full color
Text/Photo 05-7656
Set 128 or larger. 0 to 255 128
Text 05-7657
Printed Image 05-7658
Photo 05-7659
Map 05-7660
User Custom 05-7661
Red Seal Color 05-7662
Mono color
Text/Photo 05-7707
Text 05-7708
Printed Image 05-7709
Twin color
Text/Photo 05-7710
Text 05-7711
Printed Image 05-7712
Black
Text/Photo 05-7100
Text 05-7101
Printed Image 05-7102
Image Smoothing 05-7105
User Custom 05-7106
Drop Out Color 05-7107
To Next Page
Loading...
