2.Copier-specific Adjustments
© 2018 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
2-36
(4) Select [05 ADJUSTMENT MODE] and arrange the color balance by changing the setting values for
the codes from [7960] to [7987] to adjust the density for each color.
• Set the value in increments of approximately 10, while checking the copy image until the optimum
value is obtained.
• The setting value “25” corresponds to one step in the background adjustment on the control
panel.
• The value for the code corresponding to the original mode (Text/Photo, Text, or Printed Image) will
affect the copy image quality in the Full color mode and the Auto Color mode.
• The subcode varies according to the area where the density is adjusted. Refer to the table below
and set the subcode for the area to be adjusted. The background (highlight) density will vary, if the
low or middle density area is mainly adjusted. Adjusting the subcode 2 allows you to adjust the
high density area. But it will not affect the background density. Therefore, never change the value
for the high density area.
Original
mode
Color to
adjust
[05] code Subcode Recommended value
Acceptable
value range
Default
Tex t/ Ph o t o
Y (Yellow) 05-7960 0/1
Set a value larger than
128 to increase the
density.
Set a value smaller than
128 to decrease the
density.
0 to 255 128
M (Magenta) 05-7965 0/1
C (Cyan) 05-7970 0/1
K (Black) 05-7975 0/1
Tex t
Y (Yellow) 05-7961 0/1
M (Magenta) 05-7966 0/1
C (Cyan) 05-7971 0/1
K (Black) 05-7976 0/1
Printed Image
Y (Yellow) 05-7962 0/1
M (Magenta) 05-7967 0/1
C (Cyan) 05-7972 0/1
K (Black) 05-7977 0/1
Photo
Y (Yellow) 05-7963 0/1
M (Magenta) 05-7968 0/1
C (Cyan) 05-7973 0/1
K (Black) 05-7978 0/1
Map
Y (Yellow) 05-7964 0/1
M (Magenta) 05-7969 0/1
C (Cyan) 05-7974 0/1
K (Black) 05-7979 0/1
User Custom
Y (Yellow) 05-7980 0/1
M (Magenta) 05-7981 0/1
C (Cyan) 05-7982 0/1
K (Black) 05-7983 0/1
Red Seal Color
Y (Yellow) 05-7984 0/1
M (Magenta) 05-7985 0/1
C (Cyan) 05-7986 0/1
K (Black) 05-7987 0/1
Subcode Area where the density is adjusted
0 Low density area
1 Middle density area
To Next Page
Loading...
